How To Replace Burner Switch On Stove

Reassembling the stove parts in reverse order. Install the new switch into place, snapping it firmly onto the valve.

Frigidaire Range Repair How to replace the Infinite

Plug in the stove and turn on gas.

How to replace burner switch on stove. Pull the wire connector off the original infinite switch terminal and push it onto the new terminal to avoid placing the wires in the wrong positions. Pull the control knob off. Removing the burner grates, burner caps, and burner base.

Transfer one infinite switch wire at a time. If it still fails, replace the element by plugging the new one in. Remove the screws that attach the surface element control switch to the control panel.

That will expose two screws that. Check the contacts of the element prongs for cleanliness and damage. Replaced back panel and pluged in stove.

Unplug the power cord from the outlet or disconnect the power supply to the range by flipping the two circuit breakers off dedicated for the range. Remove screws under front panel and knobs. The photos below are from whirlpool stove.

Insert the new surface element control switch in the control panel and secure it with the mounting screws. Removed the knob on the front of the stove. Next, pull out the switch knob from the front of the control panel.

Shutting off power and gas to the stove. Inserted new switch into the stove and attached the 2 screws. Reconnect the electrical wires, then install the top, valve knobs, burner base and screws.

Unscrewing and replacing the damaged igniter with a new igniter. Connect wires to appropriate connections on replacement switch. Remove screws holding switch in place (behind knob) unplug each wire from switch and immediately replace in same spots on new switch.

The first step is to remove the covers from the back of the stove. Remove the two screws that were hidden by the control knob. However, if it's broken, you'll need to replace the entire igniter with a new one.

Place mounting bracket on the knob connector, and then install the switch to the main bracket covering all of the switches. Screw switch into the main bracket cover using provided screws and a phillips head screwdriver. Removed each wire from the old switch and replaced them in the same position on the new switch.

Replacing a bad burner element. Pull the surface element control switch out and transfer the wires from the existing surface element control switch to the new surface element control switch. This exposed 2 screws, removed screws and the switch came away from the stove.

Remove screws holding back vent in place. To do this, start by: If they are clean and undamaged, reinsert the element and turn it on to test it.

Once disconnected, remove switch and set aside. Need help replacing the infinite burner switch (part 316436001) in your frigidaire range? Every stove will be different.

Hold the replacement infinite switch next to the original switch.

How to Replace Your Electric Stove Burner Switch